🎯 INFORMATION REQUIRED TO PERFORM A FIELD TEST WITH OUR CORROSION INHIBITOR
This is a checklist of the information required to define the right parameters before to conduct a field test in a pipeline with our corrosion inhibitor.
🧪 PIPELINE & MATERIAL SPECIFICATIONS
- Pipeline Material:
Example: Carbon Steel (API 5L) - Test Zone Length:
500–1000 meters (Isolated section)
💧 FLUID & CHEMICAL PROPERTIES
- Fluid Type:
Crude oil, produced water, gas condensate - Chemical Composition:
[Provide complete analysis] - Emulsions / Oil-Water Ratio
- pH of Water Phase
- TDS / Salinity
- Presence of SRB (Sulfate Reducing Bacteria)
🔥 PROCESS CONDITIONS
- Pressure:
20–60 bar (300–900 psi) - Temperature:
40–80 °C - Flow Regime:
Stratified or Slug Flow - Volume Transported per Day:
[Specify bbl or m³]
⚙️ DOSING SYSTEM & EVALUATION
- Injection Pump System:
Continuous or batch mode - Suggested Dose:
400–1000 ppm - Evaluation Method:
Corrosion Coupons (or inline monitoring) - Minimum Trial Duration:
4 to 7 days
✅ Why Use Our Green Inhibitor?
- 🌿 Biodegradable & Sustainable
- 🚫 Zero VOCs or amines
- ♻️ Complies with ESG, REACH & Green Mandates
- 🔐 Safer for operators – reduces HSE risk
- 💲 Effective at Low Dose = Cost Saving per m³
🧠 NOTE TO CUSTOMER
Please provide complete fluid analysis and pipeline data to ensure an accurate test protocol.
